Scan to Print Custom Halloween Masks that Actually Fit your Face! Step by Step Tutorial!

In the spirit of Halloween I am showing how to use your Creality ferret pro scanner to go from scan to print using Meshmixer to make a fun face masks that actually fits your face. this is an Easy to follow, step by step tutorial. Enjoy! I STILL HAVE A FEW SLOTS AVAILABLE FOR AMPUTEES TO PARTICIPATE IN MY DEVICE TRIAL. If you are an amputee with the same disarticulation that I have and are interested in trying out my gear, watch this video, https://youtu.be/GztkLoWz1TE follow the directions, and get a hold of me. Here is the link to the check socket. https://www.printables.com/model/1023124-missing-parts-club-check-socket Send picture of your residual limb mashed in the check socket to: [email protected] Yes, there are quite a few conditions to participate in this trial. The thing is, this device is for a very specific amputation. It isn't a situation of one device suits all. That's part of the issue with trying to service the partial hand prosthetics market. There are like 30 different possible amputation variations, and each one requires its own setup and design. This design could conceivably meet the needs for 7 of those variations by deleting 1 or more mechanical fingers. Right now, this trial is for only 1 of those variations. Instagram at: https://www.instagram.com/acmeworksfab finally a tic tok! https://vm.tiktok.com/ZMeSKLK5G Times are tough for everyone out there, But if you have the means, I'd appreciate your support and put it to good use. Please support me on Patreon at: https://www.patreon.com/IanDavis